General MedicationsINTRAVENOUSHigh Alert

Biorphen

PHENYLEPHRINE HYDROCHLORIDE

Standard Dose

2 DOSAGE AND ADMINISTRATION BIORPHEN 500 mcg/5 mL (100 mcg/mL)/mL injection MUST NOT BE DILUTED before administration as an intravenous bolus. It is supplied as a READY-TO-USE formulation. ( 2 ) BIORPHEN 10 mg/mL injection MUST BE DILUTED before administration as an intravenous bolus or continuous intravenous infusion to achieve the desired concentration. ( 2 ) Dosing for treatment of hypotension during anesthesia Bolus intravenous injection: Initial dose is 40 mcg to 100 mcg. Additional boluses up to 200 mcg may be administered every 1 to 2 minutes as needed. ( 2 ) Adjust the dose according to the pressor response (i.e., titrate to effect). ( 2 ) Biorphen 10 mg/mL Only: Continuous intravenous infusion: 10 mcg/min to 35 mcg/min, titrating to effect, not to exceed 200 mcg/min. ( 2 ) 2.1 General Dosage and Administration Instructions During BIORPHEN administration: Correct intravascular volume depletion. Correct acidosis. Acidosis may reduce the effectiveness of phenylephrine. Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration. Do not use if the solution is colored or cloudy, or if it contains particulate matter. Discard any unused portion. BIORPHEN 500 mcg/5 mL (100 mcg/mL) and 10 mg/mL Injection have important differences in administration instructions: Administration Instructions for BIORPHEN 500 mcg/5 mL (100 mcg/mL) Injection: BIORPHEN 500 mcg/5 mL (100 mcg/mL) injection MUST NOT BE DILUTED before administration as an intravenous bolus. It is supplied as READY-TO-USE formulation. Administration Instructions for BIORPHEN 10 mg/mL Injection: BIORPHEN 10 mg/mL injection MUST BE DILUTED before administration as an intravenous bolus or continuous intravenous infusion to achieve the desired concentration: • Bolus : Dilute with normal saline or 5% dextrose in water. • Continuous infusion : Dilute with normal saline or 5% dextrose in water. The diluted solution should not be held for more than 4 hours at room temperature or for more than 24 hours under refrigerated conditions. 2.2 Dosing for Treatment of Hypotension during Anesthesia The following are the recommended dosages for the treatment of hypotension during anesthesia. BIORPHEN 500 mcg/5 mL (100 mcg/mL) Injection: The recommended initial dose is 40 mcg to 100 mcg administered by intravenous bolus. Additional boluses up to 200 mcg may be administered every 1 to 2 minutes as needed. Adjust dosage according to the blood pressure goal. BIORPHEN 10 mg/mL Injection: • The recommended initial dose is 40 mcg to 100 mcg administered by intravenous bolus. Additional boluses up to 200 mcg may be administered every 1 to 2 minutes as needed. • If blood pressure is below the target goal, start a continuous intravenous infusion with an infusion rate of 10 mcg/minute to 35 mcg/minute; not to exceed 200 mcg/minute. • Adjust dosage according to the blood pressure goal. 2.3 Preparation of a 100 mcg/mL Solution for Bolus Intravenous Administration from BIORPHEN 10 mg/mL Injection For bolus intravenous administration, prepare a solution containing a final concentration of 100 mcg/mL of BIORPHEN 10 mg/mL Injection: • Withdraw 10 mg i.e. 1 mL of BIORPHEN 10 mg/mL Injection and dilute with 99 mL of 5% Dextrose Injection, USP or 0.9% Sodium Chloride Injection, USP. • Withdraw an appropriate dose from the 100 mcg/mL solution prior to bolus intravenous administration. 2.4 Preparation of Solution for Continuous Intravenous Administration from BIORPHEN 10 mg/mL Injection For continuous intravenous infusion, prepare a solution containing a final concentration of 20 mcg/mL of BIORPHEN 10 mg/mL Injection in 5% Dextrose Injection, USP or 0.9% Sodium Chloride Injection, USP. • Withdraw 10 mg i.e. 1 mL of BIORPHEN 10 mg/mL Injection and dilute with 500 mL of 5% Dextrose Injection, USP or 0.9% Sodium Chloride Injection, USP.

Max Dose

See official label

Primary Use

1 INDICATIONS AND USAGE BIORPHEN is indicated for the treatment of clinically important hypotension resulting primarily from vasodilation in the setting of anesthesia.

Summary

Indications and usage 1 INDICATIONS AND USAGE BIORPHEN is indicated for the treatment of clinically important hypotension resulting primarily from vasodilation in the setting of anesthesia.

BIORPHEN injection is an alpha-1 adrenergic receptor agonist indicated for the treatment of clinically important hypotension resulting primarily from vasodilation in the setting of anesthesia. ( 1 ) Dosage and administration 2 DOSAGE AND ADMINISTRATION BIORPHEN 500 mcg/5 mL (100 mcg/mL)/mL injection MUST NOT BE DILUTED before administration as an intravenous bolus.

Structured Monograph

Clinical summary

Indications and usage 1 INDICATIONS AND USAGE BIORPHEN is indicated for the treatment of clinically important hypotension resulting primarily from vasodilation in the setting of anesthesia. BIORPHEN injection is an alpha-1 adrenergic receptor agonist indicated for the treatment of clinically important hypotension resulting primarily from vasodilation in the setting of anesthesia. ( 1 ) Dosage and administration 2 DOSAGE AND ADMINISTRATION BIORPHEN 500 mcg/5 mL (100 mcg/mL)/mL injection MUST NOT BE DILUTED before administration as an intravenous bolus. It is supplied as a READY-TO-USE formulation. ( 2 ) BIORPHEN 10 mg/mL injection MUST BE DILUTED before administration as an intravenous bolus or continuous intravenous infusion to achieve the desired concentration. ( 2 ) Dosing for treatment of hypotension during anesthesia Bolus intravenous injection: Initial dose is 40 mcg to 100 mcg. Additional boluses up to 200 mcg may be administered every 1 to 2 minutes as needed. ( 2 ) Adjust the dose according to the pressor response (i.e., titrate to effect). ( 2 ) Biorphen 10 mg/mL Only: Continuous intravenous infusion: 10 mcg/min to 35 mcg/min, titrating to effect, not to exceed 200 mcg/min. ( 2 ) 2.1 General Dosage and Administration Instructions During BIORPHEN administration: Correct intravascular volume depletion. Correct acidosis. Acidosis may reduce the effectiveness of phenylephrine. Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration. Do not use if the solution is colored or cloudy, or if it contains particulate matter. Discard any unused portion. BIORPHEN 500 mcg/5 mL (100 mcg/mL) and 10 mg/mL Injection have important differences in administration instructions: Administration Instructions for BIORPHEN 500 mcg/5 mL (100 mcg/mL) Injection: BIORPHEN 500 mcg/5 mL (100 mcg/mL) injection MUST NOT BE DILUTED before administration as an intravenous bolus. It is supplied as READY-TO-USE formulation. Administration Instructions for BIORPHEN 10 mg/mL Injection: BIORPHEN 10 mg/mL injection MUST BE DILUTED before administration as an intravenous bolus or continuous intravenous infusion to achieve the desired concentration: • Bolus : Dilute with normal saline or 5% dextrose in water. • Continuous infusion : Dilute with normal saline or 5% dextrose in water. The diluted solution should not be held for more than 4 hours at room temperature or for more than 24 hours under refrigerated conditions. 2.2 Dosing for Treatment of Hypotension during Anesthesia The following are the recommended dosages for the treatment of hypotension during anesthesia. BIORPHEN 500 mcg/5 mL (100 mcg/mL) Injection: The recommended initial dose is 40 mcg to 100 mcg administered by intravenous bolus. Additional boluses up to 200 mcg may be administered every 1 to 2 minutes as needed. Adjust dosage according to the blood pressure goal. BIORPHEN 10 mg/mL Injection: • The recommended initial dose is 40 mcg to 100 mcg administered by intravenous bolus. Additional boluses up to 200 mcg may be administered every 1 to 2 minutes as needed. • If blood pressure is below the target goal, start a continuous intravenous infusion with an infusion rate of 10 mcg/minute to 35 mcg/minute; not to exceed 200 mcg/minute. • Adjust dosage according to the blood pressure goal. 2.3 Preparation of a 100 mcg/mL Solution for Bolus Intravenous Administration from BIORPHEN 10 mg/mL Injection For bolus intravenous administration, prepare a solution containing a final concentration of 100 mcg/mL of BIORPHEN 10 mg/mL Injection: • Withdraw 10 mg i.e. 1 mL of BIORPHEN 10 mg/mL Injection and dilute with 99 mL of 5% Dextrose Injection, USP or 0.9% Sodium Chloride Injection, USP. • Withdraw an appropriate dose from the 100 mcg/mL solution prior to bolus intravenous administration. 2.4 Preparation of Solution for Continuous Intravenous Administration from BIORPHEN 10 mg/mL Injection For continuous intravenous infusion, prepare a solution containing a final concentration of 20 mcg/mL of BIORPHEN 10 mg/mL Injection in 5% Dextrose Injection, USP or 0.9% Sodium Chloride Injection, USP. • Withdraw 10 mg i.e. 1 mL of BIORPHEN 10 mg/mL Injection and dilute with 500 mL of 5% Dextrose Injection, USP or 0.9% Sodium Chloride Injection, USP. Warnings and cautions 5 WARNINGS AND PRECAUTIONS Exacerbation of Angina, Heart Failure, or Pulmonary Arterial Hypertension: BIORPHEN can precipitate angina in patients with severe arteriosclerosis or history of angina, exacerbate underlying heart failure, and increase pulmonary arterial pressure. ( 5.1 ) Peripheral and Visceral Ischemia: BIORPHEN can cause excessive peripheral and visceral vasoconstriction and ischemia to vital organs. ( 5.2 ) Skin and Subcutaneous Necrosis: Extravasation during intravenous administration may cause necrosis or sloughing of tissue. ( 5.3 ) Bradycardia: BIORPHEN can cause severe bradycardia and decreased cardiac output. ( 5.4 ) 5.1 Exacerbation of Angina, Heart F

Monitoring

• 5 WARNINGS AND PRECAUTIONS Exacerbation of Angina, Heart Failure, or Pulmonary Arterial Hypertension: BIORPHEN can precipitate angina in patients with severe arteriosclerosis or history of angina, exacerbate underlying heart failure, and increase pulmonary arterial pressure.
• ( 5.1 ) Peripheral and Visceral Ischemia: BIORPHEN can cause excessive peripheral and visceral vasoconstriction and ischemia to vital organs.
• ( 5.2 ) Skin and Subcutaneous Necrosis: Extravasation during intravenous administration may cause necrosis or sloughing of tissue.
• ( 5.3 ) Bradycardia: BIORPHEN can cause severe bradycardia and decreased cardiac output.

Interaction Notes

• 7 DRUG INTERACTIONS Agonistic Effects (increase in BIORPHEN blood pressure effect) can occur with monoamine oxidase inhibitors (MAOI), oxytocin and oxytocic drugs, tricyclic antidepressants, angiotensin and aldosterone, atropine, steroids, norepinephrine transporter inhibitors, ergot alkaloids.
• ( 7.1 ) Antagonistic Effects (decrease in BIORPHEN blood pressure effect) can occur with α-adrenergic antagonists, phosphodiesterase Type 5 inhibitors, mixed α- and β-receptor antagonists, calcium channel blockers, benzodiazepines and ACE inhibitors, centrally acting sympatholytic agents.
• ( 7.2 ) 7.1 Interactions that Augment the Pressor Effect The increasing blood pressure effect of BIORPHEN is increased in patients receiving: Monoamine oxidase inhibitors (MAOI) Oxytocin and oxytocic drugs Tricyclic antidepressants Angiotensin, aldosterone Atropine Steroids, such as hydrocortisone Norepinephrine transporter inhibitors, such as atomoxetine Ergot alkaloids, such as methylergonovine maleate 7.2 Interactions that Antagonize the Pressor Effect The increasing blood pressure effect of BIORPHEN is decreased in patients receiving: α-adrenergic antagonists Phosphodiesterase Type 5 inhibitors Mixed α- and β-receptor antagonists Calcium channel blockers, such as nifedipine Benzodiazepines ACE inhibitors Centrally acting sympatholytic agents, such as reserpine, guanfacine