VYVGART Hytrulo

2 DOSAGE AND ADMINISTRATION See Full Prescribing Information for instructions on dosage, preparation, and administration. ( 2.1 , 2.2 , 2.3 , 2.4 , 2.5 ) Evaluate the need to administer age-appropriate vaccines according to immunization guidelines before initiation of a new treatment cycle with VYVGART HYTRULO. ( 2.1 ) Important Administration Information VYVGART HYTRULO is for subcutaneous use only. ( 2.2 ) Prefilled syringe can be administered by patients and/or caregivers. ( 2.2 ) Vial to be administered with a winged infusion set by a healthcare professional only. ( 2.2 ) gMG: recommended dose and dose schedule Administer in cycles of once weekly injections for 4 weeks. ( 2.3 ) Prefilled syringe: 1,000 mg efgartigimod alfa and 10,000 units hyaluronidase administered over 20 to 30 seconds. ( 2.3 ) Vial: 1,008 mg efgartigimod alfa and 11,200 units hyaluronidase over 30 to 90 seconds. ( 2.3 ) Administer subsequent treatment cycles based on clinical evaluation. ( 2.3 ) CIDP: recommended dose and dose schedule Administer as once weekly injections. ( 2.4 ) Prefilled syringe: 1,000 mg efgartigimod alfa and 10,000 units hyaluronidase administered over approximately 20 to 30 seconds. ( 2.4 ) Vial: 1,008 mg efgartigimod alfa and 11,200 units hyaluronidase over 30 to 90 seconds. ( 2.4 ) 2.1 Recommended Vaccination Evaluate the need to administer age-appropriate vaccines according to immunization guidelines before initiation of a new treatment cycle with VYVGART HYTRULO. Because VYVGART HYTRULO causes transient reduction in IgG levels, vaccination with live vaccines is not recommended during treatment with VYVGART HYTRULO [see Dosage and Administration (2.3) and Warnings and Precautions (5.1) ] . 2.2 Important Dosage and Administration Instructions VYVGART HYTRULO is for subcutaneous use only. Do not administer intravenously. Do not dilute VYVGART HYTRULO. Single-Dose Prefilled Syringe VYVGART HYTRULO prefilled syringe may be administered by patients and/or caregivers after proper instruction in subcutaneous injection technique [see Instructions for Use ] . Single-Dose Vial VYVGART HYTRULO vial is to be administered with a winged infusion set by a healthcare professional only [see Dosage and Administration (2.4) ]. 2.3 Recommended Dosage for gMG Single-Dose Prefilled Syringe The recommended dosage of VYVGART HYTRULO prefilled syringe is 1,000 mg / 10,000 units (1,000 mg efgartigimod alfa and 10,000 units hyaluronidase) administered subcutaneously over approximately 20 to 30 seconds in cycles of once weekly injections for 4 weeks. Single-Dose Vial The recommended dosage of VYVGART HYTRULO vial is 1,008 mg / 11,200 units (1,008 mg efgartigimod alfa and 11,200 units hyaluronidase) administered subcutaneously over approximately 30 to 90 seconds in cycles of once weekly injections for 4 weeks. General Dosage Considerations Administer subsequent treatment cycles according to clinical evaluation. If a scheduled dose is missed, VYVGART HYTRULO may be administered up to 3 days after the scheduled time point. Thereafter, resume the original dosing schedule until the treatment cycle is completed. 2.4 Recommended Dosage for CIDP Single-Dose Prefilled Syringe The recommended dosage of VYVGART HYTRULO prefilled syringe is 1,000 mg / 10,000 units (1,000 mg efgartigimod alfa and 10,000 units hyaluronidase) administered subcutaneously over approximately 20 to 30 seconds as once weekly injections. Single-Dose Vial The recommended dosage of VYVGART HYTRULO vial is 1,008 mg / 11,200 units (1,008 mg efgartigimod alfa and 11,200 units hyaluronidase) administered subcutaneously over approximately 30 to 90 seconds as once weekly injections. General Dosage Considerations If a scheduled injection is missed, VYVGART HYTRULO may be administered up to 3 days after the scheduled time point. Thereafter, resume the original dosing schedule. Not all patients respond to VYVGART HYTRULO . Consider the appropriateness of continuing treatment in patients who experience worsening of neurological symptoms after starting VYVGART HYTRULO [see Adverse Reactions (6.2) and Clinical Studies (14.2) ]. 2.5 Preparation and Administration Instructions Single-Dose Prefilled Syringe Take the VYVGART HYTRULO prefilled syringe out of the refrigerator at least 30 minutes before injecting to allow it to reach room temperature [see How Supplied/Storage and Handling (16) ] . Do not use external heat sources to bring the syringe to room temperature. Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit. Visually inspect that the prefilled syringe solution is yellowish, clear to opalescent and devoid of particulate matter. Do not use if visible particles are present. Each prefilled syringe is for one-time use only. To administer VYVGART HYTRULO prefilled syringe, use a safety needle that is 25G, 5/8 inches in length, and thin wall type. The safety needle is not included in the carton. Choose an injection site on the abdomen (at least 2 inches away from the navel). Do not inject on areas where the skin is irritated, red, bruised, infected, tender, hard, or into areas where there are moles or scars. Rotate injection sites for subsequent administrations. Inject VYVGART HYTRULO prefilled syringe subcutaneously into a pinched skin area at an angle of 45 to 90 degrees for approximately 20 to 30 seconds. Discard any unused portions of medicine remaining in the syringe. Localized injection site reactions may occur after VYVGART HYTRULO is administered [see Adverse Reactions (6.1) ]. Monitor for clinical signs and symptoms of hypersensitivity reactions for at least 30 minutes after administration. If a hypersensitivity reaction occurs, the patient should seek medical attention and the healthcare professional should institute appropriate measures, if needed [see Warnings and Precautions (5.2) ] . For detailed instructions on the preparation and administration of VYVGART HYTRULO prefilled syringe see INSTRUCTIONS FOR USE . Single-Dose Vial Use aseptic technique when preparing and administering VYVGART HYTRULO vial. Do not shake the vial. Each vial is for one-time use only. Avoid exposure to direct sunlight. Preparation Take the VYVGART HYTRULO vial out of the refrigerator at least 15 minutes before injecting to allow it to reach room temperature [see How Supplied/Storage and Handling (16) ]. Do not use external heat sources. Check that the VYVGART HYTRULO solution is yellowish, clear to opalescent. Parenteral medicine products should be inspected visually for particulate matter prior to administration, whenever solution and container permit. Do not use if opaque particles or other foreign particles are present. Withdraw the entire content of VYVGART HYTRULO from the vial using a polypropylene syringe and an 18G stainless steel transfer needle. Remove large air bubbles, if present. Each vial contains overfill to compensate for liquid loss during preparation and to compensate for the priming volume of the winged infusion set. VYVGART HYTRULO vial does not contain preservatives. Administer immediately after preparation. Administration To administer VYVGART HYTRULO vial use a winged infusion set made of polyvinyl chloride (PVC), 25G, 12 inches tubing, maximum priming volume of 0.4 mL. Remove the transfer needle from the syringe and connect the syringe to the winged infusion set. Prior to administration, fill the tubing of the winged infusion set by gently pressing the syringe plunger until the plunger is at 5.6 mL. There should be solution at the end of the winged infusion set needle. Choose an injection site on the abdomen (at least 2 to 3 inches away from the navel). Do not inject on areas where the skin is red, bruised, tender, hard, or into areas where there are moles or scars. Rotate injection sites for subsequent administrations. Inject VYVGART HYTRULO vial subcutaneously into a pinched skin area at an angle of about 45 degrees over 30 to 90 seconds. Localized injection site reactions may occur after VYVGART HYTRULO is administered. [see Adverse Reactions (6.1) ] . Discard any unused portions of medicine remaining in the vial, the syringe and the winged infusion set. Healthcare professionals should monitor for clinical signs and symptoms of hypersensitivity reactions for at least 30 minutes after administration. If a hypersensitivity reaction occurs, the healthcare professional should institute appropriate measures if needed or the patient should seek medical attention [see Warnings and Precautions (5.2) ].

See official label

1 INDICATIONS AND USAGE VYVGART HYTRULO is indicated for the treatment of adult patients with: generalized myasthenia gravis (gMG) who are anti-acetylcholine receptor (AChR) antibody positive chronic inflammatory demyelinating polyneuropathy (CIDP) VYVGART HYTRULO is a combination of efgartigimod alfa, a neonatal Fc receptor blocker, and hyaluronidase, an endoglycosidase, indicated for the treatment of adult patients with: generalized myasthenia gravis (gMG) who are anti-acetylcholine receptor (AChR) antibody positive ( 1 ) chronic inflammatory demyelinating polyneuropathy (CIDP) ( 1 )